Administrator's Guide

Configuring HyperFabric
Information You Need
Chapter 476
12. What is the Ethernet hardware address of the second switch?
(0060b0d00256)
13. What is the Multicast address for the switches to use? (226.10.1.1)
14. What is the IP address for the LAN card on the same subnet as the
switches? (193.0.0.10)
(In Figure 4-1, this is the IP address for lan0 on node A.)
On node B:
1. How many HyperFabric adapters are installed on the node?
2. Do you want this node to interoperate with nodes running any
HyperFabric versions earlier than B.11.00.11 or B.11.11.01?
3. What is the IP address of the first adapter (clic0)? (192.0.0.2)
4. What is the subnet mask of the first adapter? (255.255.255.0)
If you do not specify a value for this, a default mask is chosen. You
will most likely just accept the default. However, in this example, we
are showing a value for the subnet mask just to illustrate the
correlation between the dummy information in Figure 4-1 and where
that information is specified or generated during clic_init and
SAM.
5. What is the IP address of the second adapter (clic1)? (192.0.8.4)
6. What is the subnet mask of the second adapter? (255.255.225.0)
7. Do you want to enable switch management? You cannot enable
switch management through SAM (you must use the clic_init
command).
As stated earlier, HP recommends that you do not enable switch
management. However, if you do enable it, you must provide the
information in items 8 through 14.
8. If switch management has been enabled, how many switches will be
configured? As stated earlier, HP recommends that you do not enable
switch management.
9. What is the IP address of the first switch (sw_clic0)? (193.0.0.20)
10. What is the Ethernet hardware address of the first switch?
(0060b0d00257)
11. What is the IP address of the second switch (sw_clic1)?
(193.0.0.21)