Administrator's Guide

Configuring HyperFabric
Information You Need
Chapter 474
Configuration Information Example
This example uses some “dummy” (that is, not valid) addresses to the
components in Figure 4-1. The dummy addresses are used only to show
the flow of the information provided as input to the clic_init command
and SAM. Do not try to use these addresses in your configuration.
To use clic_init to configure the Transparent Local Failover feature on
HMP, see the section, “Configuring HMP for Transparent Local Failover
Support - Using the clic_init command” on page 104.
Figure 4-1 Map for Configuration Information Example
node A
IP address: 193.0.0.20
IP address: 193.0.0.21
Ethernet MAC address:
Ethernet LAN
HF
Ethernet MAC address:
HF
IP address:
192.0.0.1
subnet mask:
255.255.255.0
IP address:
192.0.8.3
subnet mask:
255.255.255.0
node A
node A
IP address:
192.0.0.2
subnet mask:
255.255.255.0
IP address:
192.0.8.4
subnet mask:
255.255.255.0
node B
00:60:b0:d0:02:57
00:60:b0:d0:02:56
IP address: 193.0.0.10 IP address: 193.0.0.11
IP multicast address:
226.10.1.1
IP multicast address:
226.10.1.1
Switch ID: sw_clic0
switch 0
HF
switch 1
Switch ID: sw_clic1
adapter 0
HF
adapter 1
Adapter ID:
clic0
Adapter ID:
clic1
HF
adapter 0
HF
adapter 1
Adapter ID:
clic0
Adapter ID:
clic1
S
lan0 lan0
S