Administrator's Guide

Installing HyperFabric
Installing HyperFabric Switches
Chapter 3 63
the flat part). Otherwise, the brackets will not secure the back of the
switch properly. The following figure shows the rack with these two
brackets installed.
Step 6. When you are sure the brackets are snug against the beveled part of the
switch, tighten all four screws in brackets 1 and 2.
Step 7. For each port that will be connected to an HyperFabric adapter in an
HP 9000 system, attach the cable from the corresponding adapter. Your
connections must be copper-to-copper and fiber-to-fiber (including
cables).
Step 8. Connect the switch to the Ethernet network.
front
back
rack
rack
front of switch
(with flanges)
bracket 2
bracket 1