Administrator's Guide

Installing HyperFabric
Installing the Software
Chapter 352
The commands and files used to administer HyperFabric typically have a
prefix of clic_. CLIC stands for CLuster InterConnect, and it is used to
differentiate those HyperFabric commands/files from other
commands/files. For example, the HyperFabric command clic_init is
different from the HP-UX init command.
Each of the files shown in Figure 3-1 above is briefly described below:
• /etc/opt/resmon/dictionary/clic_01
The HyperFabric dictionary file for the Event Monitoring Service
(EMS).
• /etc/rc.config.d/clic_global_conf
The global configuration file, which contains the IP addresses for
each adapter and each HyperFabric switch (if any) in the fabric.
• /sbin/init.d/clic
The system boot startup script for the HyperFabric management
process.
• /var/adm/clic_ip_drv.trc
One of the software’s trace files. This file is created when the
clic_diag -D TCP_IP command is run.
• /var/adm/clic_ip_drv.trc0
One of the HyperFabric software’s trace files. This is the primary file
that is created when the clic_diag -C TCP_IP command is run.
• /var/adm/clic_ip_drv.trc1
One of the HyperFabric software’s trace files. This file is created
when the clic_diag -C TCP_IP command is run, and the primary
trace file (clic_ip_drv.trc0) becomes full.
• /var/adm/clic_log
The global log file that is updated by the HyperFabric management
process.
• /var/adm/clic_log.old
The backup copy of the log file that is created when the log file grows
larger than 100 Kbytes.