Administrator's Guide

Troubleshooting HyperFabric
Replacing a HyperFabric Switch
Chapter 6 157
Replacing a HyperFabric Switch
If you need to replace a faulty HyperFabric switch, follow these steps:
Step 1. If you do not have an HA environment, stop HyperFabric on all nodes
that are connected to the faulty switch. (See “Stopping HyperFabric” on
page 128.)
If you have an HA environment with two switches (where the backup
switch will have taken over when the first switch failed), disconnect all
cables attached to the faulty switch.
Step 2. Install a new switch. (See “Installing HyperFabric Switches” on
page 57.)
Step 3. If you stopped HyperFabric on all nodes connected to the switch (in step
1), start it on those nodes. (See “Starting HyperFabric” on page 109.)