Administrator's Guide

Managing HyperFabric
Stopping HyperFabric
Chapter 5 129
Using SAM
To use SAM to stop HyperFabric on a local HP 9000 system running
HP-UX 11i v2, complete the following steps:
Step 1. Start SAM.
Step 2. Select the “Networking and Communications” area.
Step 3. Select “HyperFabric.”
Step 4. Pull down the “Actions” menu and select Stop HyperFabric. Note that if
HyperFabric is not running on the system, Stop HyperFabric is grayed
out and you cannot select it.
When HyperFabric stops, a confirmation message displays. Also, the
status “HyperFabric: Not running” is displayed above the adapter
configuration area of the screen.
Step 5. Exit SAM.