Administrator's Guide

Managing HyperFabric
Displaying Status and Statistics
Chapter 5 123
Frame buffer overflow: 0
Receive on disabled endpoint: 0
Invalid endpoint ID: 0
Invalid endpoint protection key: 0
Interleaved gathered receive: 0
Interleaved multi-frame bulk messages: 0
NQ overflow: 0
Send NQ overflow: 0
Invalid slot key for NQ credit update: 0
DLPI QOS receive buffer shortage: 0
Link congestion events: 0
Max send packet retry exceeded: 0
Link or switch failure events: 0
Link or switch resume events: 1
Bad route detected: 0
Bad optional data length: 0
Invalid message received: 0
CRC error: 0
Invalid CRC word: 0
Bad frame length: 0
Receive buffer overflow: 0
Null packets generated on link reset: 2
Firmware reset notification: 0
Data corruption notification: 0
Unsupported QOS message received: 0
Invalid HMP VC ID: 0
Invalid HMP endpoint ID: 0
Invalid HMP endpoint protection key: 0
HMP message order violation: 0
Packet drops: 0
Transmit side congestion events: 1
Receive side congestion events: 0
Other Misc Statistics
Mapping message send failures: 0
============================================================================
• Example 4
If the local node is bently6, and you want to display the VRIDs, IP
addresses, switch hopcounts, and physical routes for each
HyperFabric adapter in bently6, issue this command:
clic_stat -d VRID
The generated output if the nodes are connected in a Point-to-Point
configuration could look like this: