Administrator's Guide

Managing HyperFabric
Displaying Status and Statistics
Chapter 5118
Note that the second line in the above syntax is indented for readability
purposes only. When the command is typed there should not be any
indentation.
The command parameters are as follows:
• -p enables/disables performance statistics gathering according to the
value of perf_level , which is one of the following:
TCP Enables DLPI driver statistics
when under the TCP/IP stack.
HMP Enables Hyper Messaging
Protocol (HMP) statistics
gathering.
FW Enables firmware statistics
gathering.
RST Disables/resets the DLPI driver
and HMP statistics.
Note that turning on performance statistics gathering will affect the
performance of HyperFabric, by increasing CPU usage and message
latency (the time it takes a message to get from one point to another).
It might also decrease the throughput of data. HP recommends that
you do not specify this parameter unless you are trying to
troubleshoot HyperFabric problems.
You must be logged in as root to use this parameter.
• -d specifies that you want to set the level of data displayed to
display_level , which is one of the following:
NET Displays fabric component
statistics.
CFG Displays the management
daemon (clic_mgmtd)
configuration and statistics data.
VRID Displays the virtual route
identifier information—the
VRIDs, IP addresses, switch
hopcounts, and physical
routes—for each HyperFabric
adapter in the local node.
ALL Displays all available status data.