Administrator's Guide

Managing HyperFabric
Displaying Status and Statistics
Chapter 5 117
Displaying Status and Statistics
You can get the status of and statistics associated with many of the
HyperFabric components by using the clic_stat command, which is
described below.
The clic_stat Command
The following list contains some of the information that the clic_stat
command provides:
• The current fabric map, in textual format.
• The status of one or more HyperFabric adapters.
• The global configuration information for each HyperFabric adapter
and switch (if the fabric contains switches). The information includes
the firmware type (8-bit or 32-bit), which is used for interoperability
purposes.
• The card pair information, if you configure HyperFabric in the local
failover mode (applicable to applications using HMP).
The clic_stat command can also be used to enable or disable
performance statistics gathering for the DLPI driver, the firmware and
HMP.
All of the statistics that can be displayed using the clic_stat command
are documented in the clic_stat (1M) man page on HP-UX 11.0 and
on later HP-UX releases.
If you include /opt/clic/bin in your PATH statement, you can run the
command as it is shown below. Otherwise, you must include
/opt/clic/bin as part of the command name (that is,
/opt/clic/bin/clic_stat).
To use some of this command’s parameters, you must be logged in as
root (see each parameter’s description below).
The syntax is as follows:
clic_stat [-p perf_level ] [-d display_level ] [-c adapter_ID ]
[-n
nodename ] [-?]