Administrator's Guide

Managing HyperFabric
Verifying Communications within the Fabric
Chapter 5 115
CLIC_PROBE: 256 byte packets
Source adapter id: bently6.corp3.com:clic0
Target adapter id: bently4.corp7.com:clic3
256 bytes: seq_num = 1. Packet Acknowledged.
256 bytes: seq_num = 2. Packet Acknowledged.
256 bytes: seq_num = 3. Packet Acknowledged.
256 bytes: seq_num = 4. Packet Acknowledged.
256 bytes: seq_num = 5. Packet Acknowledged.
256 bytes: seq_num = 6. Packet Acknowledged.
256 bytes: seq_num = 7. Packet Acknowledged.
256 bytes: seq_num = 8. Packet Acknowledged.
--------- bently6.corp3.com CLIC_PROBE Statistics --------
8 packets transmitted, 8 packets received, 0% packet loss.
• Example 3
If the local node is bently6, and you want to send five packets to
verify communications with the remote node bently7, using the
adapter clic0 (which is on bently6), issue this command:
clic_probe bently7 -c clic0 -p 5
CLIC_PROBE: 256 byte packets
Source adapter id: bently6.corp3.com:clic0
Target adapter id: bently7.corp4.com:clic1
256 bytes: seq_num = 1. Packet Acknowledged.
256 bytes: seq_num = 2. Packet Acknowledged.
256 bytes: seq_num = 3. Packet Acknowledged.
256 bytes: seq_num = 4. Packet Acknowledged.
256 bytes: seq_num = 5. Packet Acknowledged.
--------- bently7.corp4.com CLIC_PROBE Statistics --------
5 packets transmitted, 5 packets received, 0% packet loss.
• Example 4
If the local node is bently6, and you want to send five packets to
verify communications with the remote node bently7, using the
adapter clic0 (which is on bently6) and the route identified by
VRID 194 and switch hopcount 1, issue this command:
clic_probe -c clic0 -r 194 1 -p 5
(Remember, because you specified the -r VRID switch_hopcount
parameter, you do not need to also specify the node_name .)