Administrator's Guide

Configuring HyperFabric
Configuring HMP for Transparent Local Failover Support
Chapter 4104
Configuring HMP for Transparent Local Failover
Support - Using the clic_init command
You can configure the Transparent Local Failover feature of HMP using
clic_init also.
Let us consider the following example where we have discussed the
configuration in detail. This example uses some “dummy” (that is, not
valid) addresses to the components in Figure 4-10. The dummy
addresses are used only to show the flow of the information provided as
input to the clic_init command and SAM. Do not try to use these
addresses in your configuration.
Figure 4-10 Configuring the Transparent Local Failover feature
node A
IP address: 193.0.0.20
IP address: 193.0.0.21
Ethernet MAC address:
Ethernet LAN
HF
Ethernet MAC address:
HF2
IP address:
192.0.0.1
subnet mask:
255.255.255.0
IP address:
192.0.8.3
subnet mask:
255.255.255.0
node A
node A
IP address:
192.0.0.2
subnet mask:
255.255.255.0
IP address:
192.0.8.4
subnet mask:
255.255.255.0
node B
00:60:b0:d0:02:57
00:60:b0:d0:02:56
IP multicast address:
226.10.1.1
IP multicast address:
226.10.1.1
Switch ID: sw_clic0
switch 0
HF
switch 1
Switch ID: sw_clic1
adapter 0
HF2
adapter 1
Adapter ID:
clic0
Adapter ID:
clic1
HF2
adapter 0
HF2
adapter 1
Adapter ID:
clic0
Adapter ID:
clic1
S
lan0
lan0
IP address: 193.0.0.10 IP address: 193.0.0.11
S