Administrator's Guide

Configuring HyperFabric
Configuring HMP for Transparent Local Failover Support
Chapter 4 103
of adapters clic0 and clic1 and if the Card-Pair 1, comprises of
adapters clic2 and clic3, then the following entries are added to the
clic_global_conf file.
CARD_PAIR[0] = clic0-clic1
CARD_PAIR[1] = clic2-clic3
If you press Cancel, you remain in the main “HyperFabric
Configuration” screen.
If you press Help, help text for this task appears.
Step 6. Exit SAM.
NOTE To view the card pair information from the
/etc/rc.config.d/clic_global_conf file, select “View Local
Failover for HMP...” option in the “HyperFabric Configuration” screen.
Deconfiguring HMP for Local Failover support - Using
SAM
To use SAM to deconfigure HMP for Local Failover support, complete the
following steps:
Step 1. Start SAM.
Step 2. Select the “Networking and Communications” area.
Step 3. Select “HyperFabric”.
All HyperFabric adapter card pairs installed in the system are listed.
Step 4. Pull down the “Actions” menu and select Deconfigure Local Failover
for HMP to remove all the card pair entries from the
/etc/rc.config.d/clic_global_conf file. In the next confirmation
window that pops-up, select YES to confirm it.
If you select NO. you remain in the main “HyperFabric Configuration”
screen.
Step 5. Exit SAM.