Administrator's Guide

Configuring HyperFabric
Configuring HyperFabric with ServiceGuard
Chapter 4 95
Specify Package Name and Nodes
Specify Package SUBNET Address
Specify Package Services
Specify Package Failover Options
Specify Package Control Script Location
Specify Package Control Script Information
Specify Package Resources Dependencies
Add
Resource Name
(Navigate the Resource Subclass by double-clicking on
/net until /net/interfaces/clic/ status shows up in
the
selection box Resource Name,then select it and click
OK.)
Resource Parameters
- Input the Resource Polling Interval (for example, 10
seconds).
- Select “UP” from the “Available Resource Values” and click
“Add”.
- Click OK to accept the values.
Configuring ServiceGuard for HyperFabric Relocatable IP
Addresses
If you are using HyperFabric version B.11.00.05, B.11.11.00, or later, and
you want to use relocatable IP addresses, configure the relocatable IP
addresses with the IP[ n ] command in the package control script.
For example, to configure the relocatable address 192.0.0.3 for adapter
0 and 192.0.8.5 for adapter 1, specify this:
IP[0]= 192.0.0.3
IP[1]= 192.0.8.5