Installation Manual

43
Powering on the router
Verifying before power-on
Before powering on the router, verify the following items:
• The power modules and fan trays are correctly installed.
• The power cord and grounding cable are correctly connected.
• The power source voltage meets the requirement of the router.
• The console cable is correctly connected, the terminal or PC used for configuration has started, and
the configuration parameters have been set.
• If a CF card is used, verify that the CF card is in position.
• Make sure the installed LPUs and HIMs/MIMs are in position.
Powering on the router
• Turn on the switch of the power supply system for the router.
• Turn on the switch of the AC or DC power modules.
Displaying boot information
Power on the router, and you can see the following information:
System is starting...
Booting Normal Extend BootWare........
The Extend BootWare is self-decompressing........................Done!
****************************************************************************
* *
* HP HSR68 BootWare, Version 0.17 *
* *
****************************************************************************
Copyright (c) 2010-2012 Hewlett-Packard Development Company, L.P.
Compiled Date : Apr 10 2012
CPU Type : P2020
CPU L1 Cache : 32KB
CPU Clock Speed : 1000MHz
Memory Type : DDR3 SDRAM
Memory Size : 4096MB
Memory Speed : 667MHz
Flash Size : 8MB
cfa0 Size : 999MB
NVRAM Size : 128KB
BASIC CPLD Version : 1.0
EXTEND CPLD Version : 1.0
PCB Version : Ver.A