Installation Manual

96
NOTE:
• For a combo interface, the default operating port is the copper port. You can use either the copper por
t
or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper | fiber }
command in interface view. For more information about the combo enable { copper | fiber } command,
see
HP HSR6800 Routers Interface Command Reference .
• Use transceiver modules for the fiber ports provided by HP only. The router mi
g
ht be incompatible with
transceiver modules from other manufacturers. The system generates an alarm when a transceiver
module from another manufacturer is installed.
FIP-110 combo interface specifications
Table 34 FIP-110 copper Ethernet port specifications
Item Remarks
Connector RJ-45
Interface type Autosensing
Supported frame format
Ethernet_II
Ethernet_SNAP
Interface speed and
duplex mode
10 Mbps Half/full duplex, auto-negotiation
100 Mbps Half/full duplex, auto-negotiation
1000 Mbps Full duplex, auto-negotiation
Table 35 FIP-110 fiber Ethernet port specifications
Item Remarks
Connector LC
Transceiver module type SFP
Interface standards 802.3, 802.3u, and 802.3ab
Transmission
power
Type
Short-haul
multi-mode
(850 nm)
Mid-haul
single-mode
(1310 nm)
Long haul
(1310 nm)
Long haul
(1550 nm)
Super long
haul (1550
nm)
Minimum -9.5 dBm -9 dBm -2 dBm -4 dBm -4 dBm
Maximum 0 dBm -3 dBm 5 dBm 1 dBm 2 dBm
Receive sensitivity -17 dBm -20 dBm -23 dBm -21 dBm -22 dBm
Duplex mode 1000 Mbps, full duplex
Table 36 Transceiver modules for the FIP-110 fiber ports
Model
Central
wavelen
g
th
Connector
Optical fiber
Transmission
rate
Max. transmission
distance
SFP-GE-SX-MM85
0-A
850 nm LC
62.5/125 m
multi-mode
optical fiber
1250 Mbps
0.55 km (0.34
miles)