Installation Manual

37
Verification before power-on
Before powering on the router, verify that:
• Make sure the power modules and fan tray are correctly installed.
• The power cord is properly connected.
• The input power voltage meets the requirement of the switch.
• The console cable is properly connected, the terminal or PC used for configuration has started, and
the configuration parameters have been set.
• If you use a CF card, make sure the CF card is firmly seated in slot.
• Make sure the interface modules, if any, are correctly installed.
Powering on the router
Power on the router, and you can see the following information:
System is starting...
Booting Normal Extend BootWare........
****************************************************************************
* *
* HP HSR6600 Router BootWare, Version 1.01 *
* *
****************************************************************************
Copyright (c) 2010-2012 Hewlett-Packard Development Company, L.P.
Compiled Date : Nov 14 2011
CPU Type : P4080
CPU L1 Cache : 32KB
CPU Clock Speed : 1500MHz
Memory Type : DDR3 SDRAM
Memory Size : 4096MB
Memory Speed : 650MHz
BootWare Size : 1024KB
Flash Size : 8MB
Nand Flash size : 512MB
NVRAM Size : 128KB
BASIC CPLD Version : 1.0
EXTEND CPLD Version : 1.0
PCB Version : Ver.A
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
Starting to get the main application file--flash:/HSR6600.bin!
The main application file is self-decompressing.............................
............................................................................