HP-UX Multimedia Streaming Protocols (MSP) Release Notes

For the HP-UX 11i v1 Operating System
This section discusses the different kmadmin options that you use to load, unload, and
query the status of the rtp and rtcp modules on the HP-UX 11i v1 operating system.
You can use the following command to load the rtp and rtcp kernel modules on the
HP-UX 11i v1 operating system:
kmadmin -L rtp rtcp
You can use the following command to unload the rtp and rtcp kernel modules:
kmadmin -U rtp rtcp
You can use the following command to query the status of the rtp and rtcp kernel
modules and to check if the modules are installed on the system:
kmadmin -Q rtp rtcp
For more information on the kmadmin command, type man 1M kmadmin at the HP-UX
prompt.
For the HP-UX 11i v2 Operating System
This section discusses the different kcmodule options that you use to load, unload,
and query the status of the rtp and rtcp modules on the HP-UX 11i v2 operating
system.
You can use the following command to load the rtp and rtcp kernel modules:
kcmodule rtp=loaded rtcp=loaded
You can use the following command to unload the rtp and rtcp kernel modules:
kcmodule rtp=unused rtcp=unused
You can use the following command to query the status of the rtp and rtcp kernel
modules and to check if the modules are installed properly on the system:
kcmodule -q rtp rtcp
For more information on kcmodule, type man 1M kcmodule at the HP-UX prompt.
Verifying the MSP Installation
To verify if the MSP depot is installed successfully on your system, run the following
command:
# swlist <depot_name>
If the MSP depot is installed successfully, the following output is displayed:
• For the HP-UX 11i v1 operating system
# swlist MSP
# Initializing...
# Contacting target "hosta"...
#
# Target: hosta:/
#
Installing MSP 15