HP XP P9000 Storage Replcation Adapter 2.0 Administrative Guide
Table Of Contents
- HP XP P9000 Storage Replication Adapter 2.0 Administrative Guide
- Contents
- 1 VMware Site Recovery Manager overview
- 2 Installation procedure
- 3 Configuring SRM and HP XP P9000 disk array
- 4 Executing failover and failback with SRM
- 5 Troubleshooting RMSRA20
- 6 Support and other resources
- Glossary
- Index
Figure 8 RAID Manager configuration files example 2
NOTE: The conditions that testFailover (executed on CA/CAJ_SVOL) are:
• BC licence is not installed (does not register as Group for BC ).
• SRM or the $SplitReplication variable specifies <SplitReplication> = true.
Or:
• BC licence is installed.
• SRM or the $SplitReplication variable specifies <SplitReplication> = true.
• $RMSRATMU variable should be specified MU#, which does not exis as group for BC on
horcm*.conf .
Example for local configuration:
ENV on windows: SplitReplication=true RMSRATMU=1
Example for remote (Telnet) configuration
Figure 9 (page 16) shows an remote configuration
Figure 9 RAID Manager configuration files example 3
16 VMware Site Recovery Manager overview