HP StorageWorks Disk Array XP operating system configuration guide for HP-UX XP24000, XP12000, XP10000, SVS200, v01 (A5951-96018, June 2007)

The following host group modes (options) are available for HP-UX:
Table 2 Host group modes (options)
CommentsDefaultFunction
Host
Group
Mode
Previously MODE280InactiveDeletion of Ghost LUN12
(HP-UX 11.31 onlyInactiveTask retry ID enable33
CAUTION:
Changing host group modes for ports where servers are already installed and configured is disruptive and
requires the server to be rebooted.
Setting the System Option Modes
The HP service representative sets the System Option Mode(s) based on the operating system and
software configuration of the host.
Configuring the Fibre Channel ports
Configure the disk array Fibre Channel ports by using XP Remote Web Console (shown), XP Command
View (XP arrays only), or Command View XP Advanced Edition Software. Select the settings for each
port based on your storage area network topology. Use switch zoning if you connect different types
of hosts to the array through the same switch.
XP Disk Array Configuration Guide for HP-UX 15