HP StorageWorks Disk Array XP operating system configuration guide for OpenVMS XP24000, XP12000, XP10000, v01 (A5951-96136, June 2007)

CAUTION:
The correct host mode must be set for all new installations (newly connected ports) to OpenVMS hosts. Do
not select a mode other than 05 for OpenVMS. Changing a host mode after the host has been connected
is disruptive and requires the server to be rebooted.
Setting the System Option Modes
The HP service representative sets the System Option Mode(s) based on the operating system and
software configuration of the host.
Configuring the Fibre Channel ports
Configure the disk array Fibre Channel ports by using XP Remote Web Console (shown), or XP
Command View. Select the settings for each port based on your storage area network topology. Use
switch zoning if you connect different types of hosts to the array through the same switch. For detailed
procedures, refer to HP StorageWorks XP LUN Manager User's Guide.
XP Disk Array Configuration Guide for OpenVMS 15