HP XP P9000 Storage Replcation Adapter 2.0 Administrative Guide
Table Of Contents
- HP XP P9000 Storage Replication Adapter 2.0 Administrative Guide
- Contents
- 1 VMware Site Recovery Manager overview
- 2 Installation procedure
- 3 Configuring SRM and HP XP P9000 disk array
- 4 Executing failover and failback with SRM
- 5 Troubleshooting RMSRA20
- 6 Support and other resources
- Glossary
- Index
• For an RMSRA20 configuration using local connection, enter the HORCM instance to
connect to the RAID Manager instance via RMSRA20, specifying the following formats:
Figure 26 Configure the virtualization adapter for local configuration
◦ Enter HORCMINST=X to connect to HORCMINST=X on the Windows Host. Enter
Username & password as dummy.
NOTE: If the array is set as the authentication mode command device, Enter
Username & password (sraadmin) for the array user.
Verify that the Array Manager summary screen shows SRA is the HP XP P9000 Virtualization
Adapter.
Figure 27 (page 40) shows a sample screen shot of the Array Manager summary screen.
Configuring SRM (AM) to communicate with RMSRA20 39