HP StorageWorks XP Disk Array Configuration Guide for Novell Netware XP24000, XP20000, XP12000, XP10000 (A5951 - 96055, September 2007)

connected by a fabric switch. Also, you must specify FC-AL or point-to-point in the “Mode” field of
the Change Port Mode pane. The default is FC-AL.
If you are using a fabric switch, consult the switch's documentation to determine whether FC-AL or
point-to-point should be used. Some fabric switches require that you specify point-to-point to get the
system running.
For detailed topology information, refer to the HP StorageWorks SAN Design Reference Guide at:
http://www.hp.com/go/sandesign.
Figure 2 Arbitrated loop fabric topology example
Table 2 Fabric topology settings
ProvidesConnection parameterFabric parameter
Not supportedFC-ALON
NL-port (private arbitrated loop)FC-ALOFF
Not supportedPoint-to-pointON
Not supportedPoint-to-pointOFF
Installing and configuring the host
This section explains how to install and configure Fibre Channel adapters (FCAs) that connect the
host to the disk array.
Loading the operating system and software
Follow the manufacturer's instructions to load the operating system and software onto the host. Load
all OS patches and configuration utilities supported by HP and the FCA manufacturer.
Installing and configuring the FCAs
Install and configure the Fibre Channel adapters using the FCA manufacturer's instructions.
Configuring NetWare Client
NetWare 6.x
Installing and configuring Novell Netware for the XP disk array16