HP XP P9000 Spreadsheet User Guide (AV400-96523, November 2012)

The parameters are described in the following table.
CharactersValuesDescriptionParameterColumn
First Layer: Information about external volumes and the primary path.
5 decimal digits or
less
0 to 63231Path group number.PathGroupA
2 digits or less1A to GRPort number of the primary path.PortB
16 hexadecimal
digits
0000000000000000
toFFFFFFFFFFFFFFFF
WWN of the primary path.WWNC
4 hexadecimal
digits or less
0000 to 0FFFLU number set to the external volume.LUND
Grp: 5 decimal
digits or less
Grp: 1 to
16384
External volume group number and its sequential number.
The format should be EGrp-VPG (for example,
E16384-4096).
ExGE
VPG:4 decimal
digits or less
VPG: 1 to 4096
N/ANormalAttributeF
• Normal: Maps an external volume.
R-CMD
• R-CMD: Maps a command device.
2 decimal digits or
less
0 to 31CLPR that is used to access the external volume.CLPRG
Second Layer: Information about alternate paths. Specify the paths in the order of descending priorities.
N/AN/AIdentifier+A
2 digits or less1A to GRPort number of the alternate path.PortB
16 hexadecimal
digits
0000000000000000
to
FFFFFFFFFFFFFFFF
WWN of the alternate path.WWNC
Third Layer: Information about the LDEV to be created in the external volume.
N/AN/AIdentifier+A
+B
2 hexadecimal
digits or less
00 to 01LDKC numberLDKCC
2 hexadecimal
digits or less
00 to FECU numberCUD
2 hexadecimal
digits or less
00 to FFLDEV number. Specify a number not currently assigned.
Note, though, that LDEV numbers may be assigned in
LDEVE
another emulation group (grouped by 32 LDEV numbers),
in which case you cannot user them.
For more information, see the HP P9000 Provisioning for
Open Systems User Guide or the HP P9000 Provisioning
for Mainframe Systems User Guide.
Check to see if a number is assigned. To do this, open
RWC and check the LDEV tab on the Basic Information
Display dialog box (File > Go > Basic Information).
4 hexadecimal
digits or less
0004 to FFFESSID assigned to the range of the LDEV numbers. Use the
SSID shown in the output file from the
SSIDF
ExternalStorage_Get_def.spd spreadsheet for the
range. If you create an LDEV that does not have any SSID,
specify an SSID that is not written in the output file.
Running CLI-based spreadsheets 43