HP XP P9000 Smart Manager for Mainframe User Guide (TB589-96001, July 2013)

BLKSIZE
(bytes)
LRECL
(bytes)
RECFMDSORG
Library type (DD name
#
)
6,144-UPO
Load library for LINKLIB
(HPQKLNKD)
6,144-UPO
Load library for LPALIB
(HPQKLPAD)
6,16080FBPO
Cataloged procedure library
(HPQKPRCD)
6,16080FBPO
REXX Exec library, fixed length format
(HPQKEXED)
6,120255VBPO
REXX Exec library, variable length format
(HPQKEXVD)
6,16080FBPO
ISPF panel library
(HPQKPNLD)
6,16080FBPO
ISPF message library
(HPQKMSGD)
6,16080FBPO
ISPF table library
(HPQKTABD)
#
The DD name specified with the HPQKT1AL sample JCL (allocates the distribution and target lib-
raries) that was used when installing with SMP/E. The dataset name is the one specified in each
DD statement.
Related topics
• Performing an installation using SMP/E, page 27
• Appendix D, page 211
Notes on when Business Continuity Manager is installed
This section provides notes on registering a user SVC and setting environment variables and system
symbols when installing Smart Manager for Mainframe in an environment where Business Continuity
Manager is installed.
Notes on when registering a user SVC if Business Continuity Manager is installed
Smart Manager for Mainframe and Business Continuity Manager share the same user SVC. Therefore,
you must compare the version of the currently enabled user SVC registered by Business Continuity
Manager and the version of the prerequisite user SVC for Smart Manager for Mainframe, and then
you must use the user SVC of the later version.
To confirm the version of the currently enabled user SVC, use the YKINSCHK command of Business
Continuity Manager.
Installation and Setup54