HP XP P9000 Smart Manager for Mainframe User Guide (TB589-96001, July 2013)

START KTSETENV,PARM='YKLCNSE=HPQ1'
START KTSETENV,PARM='YKLCNS2=HPQ2'
• When specifying whether to use the system logger service to collect event logs
START KTSETENV,PARM='LOGPUT=LOGR' (if using the system logger service)
START KTSETENV,PARM='LOGPUT=SAM' (if not using the system logger service)
• When specifying whether to output CLI command execution logs to SYSLOG
START KTSETENV,PARM='SYSLOG=YES' (if outputting to SYSLOG)
START KTSETENV,PARM='SYSLOG=NO' (if not outputting to SYSLOG)
TIP:
This setting is invalidated if an IPL is performed again. We recommend that you perform either of the
following settings in case that you need to perform an IPL again the next time:
• Add the KTSETENV command to the COMMNDxx parmlib member to automatically set the envir-
onment variables when an IPL is performed again.
• For the IEASYMxx parmlib member, specify the system symbols so that the statically-registered
settings will be used the next time an IPL is performed.
TIP:
We recommend that you use either the environment variables or the system symbols to specify both
prefix-1 and prefix-2. If you use the environment variable to specify prefix-1 and use the
system symbol to specify prefix-2, the process of determining the prefixes will be complicated.
TIP:
The license (name of the license information dataset) for Smart Manager for Mainframe takes effect
when the KTLOAD command is first executed after the license is registered. Even if you used the
KTSETENV command to modify a prefix of the license information dataset name while CLI commands
were being executed, the corresponding license takes effect after the KTLOAD command is executed
the next time.
CAUTION:
Environment variables are shared by Smart Manager for Mainframe and Business Continuity Manager.
Therefore, you must be careful when setting the environment variables in an environment where
Business Continuity Manager is installed.
Operations to be performed in the next step
• Settings required for registering a license in the ISPF panel
Installation and Setup38