HP XP P9000 Smart Manager for Mainframe User Guide (TB589-96001, July 2013)

If you are not using SMP/E for the installation, you do not need to create a backup in the distri-

bution library.

Related topics

• Installing Smart Manager for Mainframe, page 24

• Settings required for using CLI commands (registration for authentication), page 29

• Setting RACF security for CLI commands, page 31

• Settings for using environment configuration commands, page 33

• Registering a user SVC, page 33

• Setting the operating environment for Smart Manager for Mainframe (setting environment variables

or system symbols), page 36

• Settings required for registering a license in the ISPF panel, page 40

• Registering a license for Smart Manager for Mainframe , page 42

• Checking the setup, page 51

• Calculating required memory, page 52

• Settings required for collecting event logs, page 53

• Backing up Smart Manager for Mainframe to the distribution library, page 53

• Notes on when Business Continuity Manager is installed, page 54

Installing Smart Manager for Mainframe

This section provides an overview and the procedure for installing Smart Manager for Mainframe.

Flow of operations during installation

After transferring the load module for Smart Manager for Mainframe to a host machine, you can

install Smart Manager for Mainframe using SMP/E. Alternatively, you can install it directly in the

target library without using SMP/E.

The following figure illustrates the flow of operations when installing Smart Manager for Mainframe.

Figure 12 Flow of operations during installation of Smart Manager for Mainframe