HP XP P9000 Smart Manager for Mainframe Messages (TB589-96003, July 2013)

Type of error
Error details
Error
code
OtherSMARTPATHCMDCAJCAACABC
NNNNNYYN
A CA/CAA copy pair cannot be made because
the volume specified to be the P-VOL is a system
residence volume.
C3DA
NNNNNYYNThe S-VOL is not in the suspend status.
C3DB
NNNNNYNN
A copy pair cannot be made because CAA and
CA cannot be specified simultaneously.
C3FE
YNNNYYYN
Commands that use CA copy pairs, CAJ copy
pairs, or the Remote DKC Control Function cannot
be executed because the number of executable
paths is less than the minimum value.
C825
NNNYNNNN
The command for registering command devices
via the Remote DKC Control Function (YKBLDCMD)
cannot be executed because the specified volume
does not exist.
C8D1
Table 64 Details of error codes CBxx
Type of error
Error details
Error
code
OtherSMARTPATHCMDCAJCAACABC
NNNNNYNN
A copy pair cannot be made because there was
an attempt to make a copy pair for both directions
with the same C/T group ID.
CB10
NNNNNYNN
A CAA copy pair cannot be created for one of the
following reasons:
• The C/T group ID specified in the RCU is
already used for CAJ(OPEN).
• A total of 128 C/T groups are used in the
RCU for CAJ(OPEN) and CAA(MF/OPEN).
CB12
NNNNNYNN
A copy pair cannot be added to a C/T group
where the P-VOL and the S-VOL are being
swapped.
CB18
NNNNNYYNA dummy volume cannot be created on the S-VOL.
CB1D
NNNNNYYN
The current RCU version does not support Fibre
CA or CAA.
CB1F
NNNNNYYN
Fibre CA or CAA has not been installed on the
RCU.
CB60
NNNNNYNN
Copy pairs with Fibre and ESCON paths cannot
exist within the same C/T group.
CB61
NNNNNYYN
Copy pairs with Fibre and ESCON paths cannot
exist within the same storage system.
CB62
Storage system sense byte information266