HP XP P9000 Smart Manager for Mainframe Messages (TB589-96003, July 2013)

Explanation and recommended actionsMessage textMessage ID
An error occurred while registering the journal group to EXCTG.
Register the error code and determine the cause of the problem. After
removing the cause of the problem, execute the YKMAKE command
again with a SELECT(COND) specification to register the journal group
to EXCTG.
This message is output until the corresponding EXCTG registration
process is executed using the YKMAKE command again.
JNLG (string)
The journal type not being registered (the journal type of the
definition, rather than of the storage system)
R-JNL: Journal of the secondary site
M-JNL: Journal of the primary site
jj (hexadecimal number)
The journal group number specified by the consistency group ID
or the sub consistency group ID (00-FF)
m (decimal number)
Mirror ID (0-3)
e (decimal number)
EXCTG ID (0-3)
ssssssssssss (decimal number)
Storage system serial number
cccc (hexadecimal number)
Arbitration command device number (0000-3FFF)
FFFF is displayed for the supervisor disk controller.
nnnn (hexadecimal number)
Error code
For details about the error codes, see XXX
An error occurred while adding JN-
LG to EXCTG. (JNLG=jj, MIR-
ROR=m, EXCTG=e,
SN=ssssssssssss, CDEV=cccc,
CODE=nnnn)
Y0KZ297E MSG
SC=44 RC=44
Processing is terminating because the timeout limit has expired while
waiting for the EXCTG registration with the YKEWAIT command.
Correct the timeout value or check that the status to be monitored is
correctly specified. Also, check if the journal group is registered to
EXCTG.
The REXX variable is invalid (remains as it was prior to the YKEWAIT
command) if this message is output.
Timeout limit has expired while
waiting for EXCTG registration pro-
cess.
YKZ298W MSG
SC=4 RC=4
Messages190