HP XP P9000 RAID Manager Reference Guide (T1610-96061, January 2014)

Output of the raidvchkscan command with -v aou option:
Used(MB): Displays the usage size the allocated block on this LUN. Range: 0 ≤ Used (MB) <
LU_CAP(MB) + 42MB
LU_CAP(MB): Displays the LUN capacity responded to the 'Readcapacity' command as SCSI
interface.
LU_CAP(BLK): Displays the LUN capacity (in block/512 bytes) responded to the 'Readcapacity'
command as SCSI interface.
U(%): Displays the usage rate of the allocated block on the Thin Provisioning pool containing this
LU.
T(%): Displays the threshold rate being set to the Thin Provisioning pool as high water mark.
PID: Displays the Thin Provisioning pool ID assigned to this Thin Provisioning volume.
raidvchkscan for Continuous Access Journal
The raidvchkscan command supports the (-v jnl [t] [unit#]) option to find the journal volume list. It
also displays any information for the journal volume.
Syntax
raidvchkscan { -h | -q | -z | -I[H][M][instance#] or
I[TC][SI][instance#] | -v jnl [t] [unit#] | [ -s <Seq#>]
| [ -f[x ] | }
Options and parameters
DescriptionOption
Displays Help/Usage and version information.-h
Terminates the interactive mode and exits the command.-q
Makes the raidvchkscan command enter the interactive mode. The -zx option guards performing
of the HORCM in the interactive mode. When this option detects a HORCM shut down, interactive
mode terminates.
-z or -zx
OpenVMS cannot use the -zx option.
Specifies the command as [HORC]/[HOMRCF] or [Continuous Access Synchronous]/[Business
Copy], and used when specifying the RAID Manager instance number.
-I[H][M]
[instance#]
or
-I[TC][SI]
[instance#]
Used to specify the Seq# (serial#) of the storage system when this option cannot specify unitID
which is contained for '-v jnl' option. If this option is specified, the unitID which is contained in '-v
jnl' is invalid.
-s <Seq#>
Displays the LDEV number in hexadecimal notation.-fx
Displays information for the journal volume.-v jn
Displays the DOW, DPW, and APW time-out values for controlling the journal.-v jnlt
Returned values
--
Error codes
--
90 Data management commands