HP XP P9000 RAID Manager Reference Guide (T1610-96061, January 2014)

Serial#: Product serial number.
WWN: Displays the external WWN.
PHY_PORT: Displays the port number of the physical port in a resource ID takeover configuration.
Displaying the information of the port CL4-E.
# raidcom get port -port CL4-E
PORT LOGIN_WWN Serial# -
CL4-E 210000e08b0256f8 63528 OLA_NODE0_CTL_0
CL4-E 210000e08b039c15 63528 OLA_NODE1_CTL_0
Description of each column in output example
PORT: Displays the port numbers.
LOGIN_WWN: Displays WWN of the host adapter login to this port.
Note: Only the currently connected WWN is displayed unlike the display on Remote Web Console.
Serial#: Product serial number.
For example, for getting information on FCoE option:
# raidcom get port -port CL4-E -key opt
PORT ENMA VLAN_ID FPMA
VPS VP_I FCF_ICL4-E e3:00:00:e0:8b:02 0x03fe
e2:00:00:e0:8b:02 DWN 0x00 0x0000
Description of each column in output example.
PORT: Displays the port number.
ENMA: Displays Enode MAC address setting to this port.
VLAN_ID: Displays the VLAN identifier.
FPMA: Displays FP MAC address setting to this port.
VPS: Displays the virtual port status.
• DWN: the Link status is in Link Down.
• LOT: the Link status is in Link Up and Log-Out.
• LIN: the Link status is in Link Up and Log-In.
VP_I: Displays the virtual port index (zero is currently displayed).
FCF_I: Displays the FCoE index (zero is currently displayed).
raidcom modify port
This sets the attribute value of the specified port.
When the value other than the port attribute value is specified, the specified port must be
"TYPE=FIBRE or FCoE package and ATTR=TAR". If not, this command is rejected with EX_ENOOBJ.
When using a package of Fibre Channel over Ethernet, specify Port speed: 10G, Port topology:
f_port. In this case, port attribute cannot be changed.
Syntax
raidcom modify port -port <port#>{[-port_speed <value>]
[-loop_id <value>][-topology <topology>]
[-security_switch {y | n}]
| -port_attribute <port attribute>}
188 Configuration setting commands