HP XP P9000 RAID Manager Reference Guide (T1610-96061, January 2014)

5 Configuration setting commands
This chapter provides the specifications for the RAID Manager configuration setting (raidcom)
commands.
raidcom
Specifies a configuration change.
Executes by specifying respective parameters and values that are expressed in (page 138) and
later.
Syntax
Displaying help
raidcom { [-h]
Log-in and log-out
raidcom {-login [<user_name> <password>] | -logout] [-s <seq# >
| -u <unit#>] [-I[H][M] <instance#>] [-I[CA][BC] <instance#>]
Configuration change: line-by-line mode
raidcom <action> <object> [<param> <value>…] [-fx] [-checkmode <check mode>] [-store <filename>]
[-nomsg] [-login [<user_name> <password>] [-resource <resource_grp_id>…] | -logout] [-s <seq# > | -u
<unit#>] [-I[H][M] <instance#>] [-I[CA][BC] <instance#>]
Configuration change: transaction mode
raidcom -zt <filename> [-load <work_filename>]
[-checkmode <check mode>]
Options and parameters
DescriptionOption
Displays help of raidcom.[-h ]
Specifies user authentication for the storage system. Specifies user name and password.[-login [<user_name>
<password>]]
If no user authentication is done yet and the -login option is omitted, the input of the user name
and the password is required. And, in case of omitting the user name and the password by
specifying -login option, the input of the user name and the password is required.
The maximum number of the user who can login at same time is 512.
Deletes the cache of the session control table in the storage system and logs out from the storage
system (command device). Also deletes all the authentication files corresponding to the storage
system.
[-logout]
At the time of next login, the RAID Manager command requires the user name and the password.
If the same user is set for multiple hosts, the session control table of each host is managed so
that the logout will be applied only to the relevant host.
Specifies the serial number.[-s <Seq#>]
Specifies the unit ID of command device as HORCM_CMD of configuration file.[-u <Unit#>]
Specifies CCI instance number by specifying the command as HORC/HOMRCF or Continuous
Access Synchronous/Business Copy. If you specify only -I, the command refers to the setting
of HORCC_MRCF environment variable.
[-I[H][M] <instance#>]
or [-I[CA][BC]
<instance#>]
Specifies each command name that is expressed in (page 138) and later section and the
parameters and values that are required at each operation.
<action> <object>
[<param> <value>…]
Displays the LDEV number in hexadecimal notation.[-fx]
Specifies when executing Precheck function (execute checking commands only). It specifies the
following value.
[ -checkmode < check
mode> ]
raidcom 131