HP XP P9000 for Compatible FlashCopy Mirroring User Guide (AV400-96600, January 2014)

Table 27 ANTRQST macro command parameters (REQUEST=FCESTABLISH) (continued)
DescriptionValueParameter
specify this number, use the TGTSERIAL, TGTLSS, TGTDVC parameters
instead of TDEVN.
Establishes the relationship without using the Preserve Mirror FlashCopy
function. If PRESMIR is not specified, NO is set by default.
NOPRESMIR
Establishes the relationship using the Preserve Mirror FlashCopy function.
If the relationship cannot be established, the system rejects the command.
TGTPPRIM=YES must be specified at the same time.
REQ
Establishes the relationship using the Preserve Mirror FlashCopy function.
If the relationship cannot be established, the copy operation is executed
PREF
using the existing FlashCopy to PPRC Primary Volume function.
TGTPPRIM=YES must be specified at the same time.
Specifies the serial number of the storage system containing the T-VOL
on which you want to perform the FCESTABLISH command. Use this
Serial number of the
storage system containing
the T-VOL
TGTSERIAL
parameter when the TGTUCB parameter is NO or the REMOTE parameter
is YES.
Specifies the CU number of the T-VOL on which you want to perform the
FCESTABLISH command. Use this parameter when the TGTUCB parameter
is NO or the REMOTE parameter is YES.
T-VOL CU numberTGTLSS
Specifies the LDEV number of the T-VOL on which you want to perform
the FCESTABLISH command. Use this parameter when the TGTUCB
parameter is NO, or the REMOTE parameter is YES.
T-VOL LDEV numberTGTDVC
You use the Remote FlashCopy function to establish a relationship.YESREMOTE
You do not use the Remote FlashCopy function.NO
NO is the default setting.
Specifies the Cnt Ac-S Z source device number (device address).Cnt Ac-S Z source device
number
DEVN
Use this parameter when REMOTE is YES.
Specifies the serial number of the storage system containing the S-VOL
on which you want to perform the FCESTABLISH command.
Serial number of the
storage system containing
the S-VOL
SRCSERIAL
Use this parameter when REMOTE is YES.
Specifies the CU number of the S-VOL on which you want to perform the
FCESTABLISH command.
S-VOL CU numberSRCLSS
Use this parameter when REMOTE is YES.
Specifies the LDEV number of the S-VOL on which you want to perform
the FCESTABLISH command.
S-VOL LDEV numberSRCDVC
Use this parameter when REMOTE is YES.
Specifies the SSID of the CU on which you establish the FlashCopy
relationship.
SSIDSSID
Use this parameter when REMOTE is YES.
Can specify the target T-VOLs as TSE-VOLs.YESSETGTOK*
Cannot specify the target T-VOLs as TSE-VOLs.NO
*Valid in Compatible FlashCopy SE.
Establishing relationships by volumes for Compatible FlashCopy 57