HP XP P9000 for Business Continuity Manager Software Reference Guide

The following figure shows the Copy Group Detail Definition panel.
Copy Group Detail Definition Row 1 to 1 of 1
Command ===> Scroll ===> PAGE
2008/03/04 10:59:06
Copy Group Type : UR Copy Group ID : GRP1UR2
Description . . . . . . . . . . . . . COPY GROUP 5
Primary Device Address Domain . . . : SF
Secondary Device Address Domain . . : LA
/ Enable EXCTG Attributes EXCTG ID(Forward) 0 EXCTG ID(Reverse) 0
------------------------------------------------------------------------------
Supported actions: e(Edit), d(Delete) / Use Container
Grp C/T ID Primary ----------- Secondary --------- Path ID
AC Num sub Pair(s) S S/N ArbCdev S S/N ArbCdev
1 0C 0C 1 S 14002 14001 00
******************************* Bottom of data ********************************
F1=Help F3=Exit F4=Attr F5=Add F6=Sort F7=Backward
F8=Forward F12=Cancel
“Items in the Copy Group Detail Definition panel” (page 69) describes the items in the Copy Group
Detail Definition panel. Note that changes for each item will be applied to the storage system
settings when the copy pair is reloaded (by executing the YKLOAD command) and then created.
For Continuous Access Synchronous for Mainframe copy pairs with the HyperSwap attribute,
because Business Continuity Manager cannot perform copy pair operations, if you change the
definitions of the items that require the YKMAKE command to make changes, the changes will not
be applied to the storage system settings.
Table 47 Items in the Copy Group Detail Definition panel
When effectiveDescriptionItem
When the YKMAKE
command is executed
1
Copy type of the copy groupCopy Group Type
N/ACopy group IDCopy Group ID
N/AA description of the copy group (can be edited)Description
N/APrimary DAD IDPrimary Device Address
Domain
N/ASecondary DAD IDSecondary Device Address
Domain
When the YKMAKE
command is executed
1
.
Specify / to define an EXCTG attribute.
2
This is only effective when the copy type is CAJ; if the copy
type is other than CAJ, an error message is displayed.
Enable EXCTG Attributes
When the YKMAKE
command is executed.
Specify an EXCTG ID (0 to 3) for copying in the forward
direction.
EXCTG ID (Forward)
Unless all volumes are
SIMPLEX, execution
might not be executed
properly.
1
When the YKMAKE
command is executed.
1
Specify an EXCTG ID (0 to 3) for copying in the reverse
direction.
EXCTG ID (Reverse)
When the YKMAKE
command is executed.
1
Select to define a container.
This check box cannot be cleared if there are multiple copy
groups.
Use Container
Discover/Define Configuration panel (configuration file definition) 69