HP XP P9000 for Business Continuity Manager Software Reference Guide

NOCANCEL
Does not execute the YKSUSPND command with the CANCEL parameter specified. You can specify
this value only if you specified DUPLEX as the startup status.
Processing for Changing to the Startup Status
This section describes the processing of changing the copy group to the startup status when ADJUST
is specified for the CGSTARTUPSTATUS parameter. The copy group is sequentially searched for
a copy pair in the status indicated in the copy pair status column in “Processing for the Specified
Startup Status” (page 370). If such a copy pair with the indicated status is found, the processing in
the processing column is performed for the copy group.
Table 163 Processing for the Specified Startup Status
ProcessingCopy pair statusSpecified startup status
Does nothing.All SIMPLEXSIMPLEX
Places the monitoring status of all copy
groups specified in the CGID parameter
to INACTIVE.
SWAPPING
TRANS
INVALID
SUSPVS
REVRSY
CONSLOST
Executes the following commands:PENDING
• YKDELETE
DUPLEX
• YKEWAIT GOTO(SIMPLEX)
SUSPOP
SUSPCU
SUSPER
HOLD
HOLDER
HOLDTRNS
NODELTA
Does nothing.All DUPLEXDUPLEX
PENDING
Places the monitoring status of all copy
groups specified in the CGID parameter
to INACTIVE.
SIMPLEX
SWAPPING
SUSPER
TRANS
HOLD
HOLDER
HOLDTRNS
NODELTA
REVRSY
INVALID
370 BCM Monitor Parameter Files