HP XP P9000 for Business Continuity Manager Software Reference Guide

When the F6=Scan key is pressed after the items in Table 15 (page 34) are specified, volumes
are scanned within the specified range. If an invalid character is specified, or if the value specified
for Start is greater than the value specified for End, an error message prompts you to re-enter the
values.
After the local scanning operation, the number of detected volumes is displayed. The new information
is displayed in the Discover HP Storage System panel. After the NG scan is completed, the panel
transitions to the CU Selection List for Remote Storage System panel. The information on the scanned
volume configuration is saved in the disk configuration definition file. A name that conforms to the
value of Configuration File Prefix and Local Device Address Domain ID in the Set Defaults panel or
Non Gen'ed Device Address Domain is assigned to the file using the following format:
prefix.DSK.SNnnnnn.dad-id
When entering prefix and dad-id information, the names must be specified using no more than
44 characters.
NOTE: Table 16 (page 35) describes the command devices used when an NG scan is performed.
If you want to change the command device to be used, modify the environment according to
information in Table 16 (page 35).
Table 16 Command devices used when NG Scan is performed
Command device used when an NG
scan is performed
First storage system of the route list
specified for Preset RouteListID in the
Set Defaults panel
Value specified for Remote DKC
Function in the Set Defaults panel
The first command device of the list that
was sorted in ascending order by CU
Not applicableN
If the storage system is not a target for
the NG scan
Y
and CCA. The list includes the
command devices that have been
detected by the local scan.
The command device of the first storage
system in the route list that has been
If the storage system is a target for the
NG scan
specified for Preset RouteListID and
Preset Route Label.
CU Selection List for Edit devn panel
If any of the following operations are executed, the CU Selection List for Edit devn panel with a
list of CUs detected by the remote scan or NG scan is displayed.
• The F6=Scan key is pressed in the Scan Remote Device Address Extent panel.
• Non Gen'ed is selected and the F6=Scan key is pressed in the Scan Device Address Extent
panel.
• e is specified in the AC column in the Discover HP Storage System panel.
The following figure shows the CU Selection List for Edit devn panel.
CU Selection List for Edit devn Row 1 to 1 of 1
Command ===> Scroll ===> PAGE
2008/01/28 14:19:14
Supported actions: s(Select), e(Edit devn)
Device Address Domain : R5L
Description . . . : DISCOVERED-REMOTE-STORAGE
Storage System S/N : 14001 Model : USP uCode : 500970FF IFType : 1616
Software Keys CA( Y ) CAA ( Y ) BC ( Y ) CAJ ( Y )
------------------------------------------------------------------------------
AC CU SSID Dummy Devn Information
01 2354 FF30
******************************* Bottom of data********************************
Discover/Define Configuration panel (configuration file definition) 35