HP XP P9000 for Business Continuity Manager Software Reference Guide

Scan Device Address Extent panel
When you press the F4=Discover key in the Discover HP Storage System panel, the Scan Device
Address Extent panel for scanning the volumes of the storage system connected to the host is
displayed.
The following figure shows the Scan Device Address Extent panel.
Scan Device Address Extent
Command ===>
2008/03/14 16:42:03
Select one field from among Device Num, Volser, and Non Gen'ed by entering
"/". Next, specify any contiguous range of device address, and then press the
F6=Scan key to discover HP storage systems and devices.
Device Num ( ) | Start: End:
Volser ( ) | Start: End:
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
------------------------------------------------------------------------------
Non Gen'ed ( )
Supported action: s(Select)
AC
Non Gen'ed Device Address Domain
Storage System S/N
Device Address | Start CU: CCA:
| End CU: CCA:
F1=Help F3=Exit F6=Scan F12=Cancel
Table 15 (page 34) lists and describes the items in the Scan Device Address Extent panel.
Table 15 Contents of the Scan Device Address Extent panel
DescriptionItem
To scan device numbers, enter the check mark (/), and then specify the range of device numbers
to be scanned in Start and End. Enter device numbers in ascending order by hexadecimal number.
Device Num
NOTE: The device number range cannot be omitted. To scan only one volume, specify the same
value for both Start and End.
To scan volume serial numbers, add a check (/), and then specify the range of the volume serial
numbers to be scanned in Start and End. Order by EBCDIC code.
Volser
Displays the number of volumes detected by a local scan.XXXXX...X
When the target is a Non Gen'ed volume, add a check mark (/) and specify the following
information: DAD ID to which the storage system to be scanned belongs, the serial number, and
the range of device addresses.
Non Gen’ed
Specify an action.
• s: Specify this option to select a DAD ID that has been NG-scanned and a storage system serial
number. The “Storage System/DADID Selection List panel” (page 39) is displayed.
AC
DAD ID to which the storage system to be scanned belongsNon Gen’ed
Device Address
Domain
.
Serial number of the storage system to be scanned.Storage System
S/N
Specify the Start and End of the device address (CU and CCA) range to be scanned.Device Address
Specify the hexadecimal number in ascending order. If the CCA is omitted, the Start and End will
be set to 00 and FF respectively.
34 ISPF panels