HP XP P9000 for Business Continuity Manager Software Reference Guide

SELECT({ALL|COND})
Specify the selection method for copy pair to be manipulated by the command. When not specified,
ALL is assumed.
ALL
All the copy pairs in the copy group are to be manipulated by the command. Note that if the DEVN
parameter is specified, the copy pair specified for the parameter is the execution target of the
command.
COND
The pairs to be manipulated by the command depend on their volume status. For more information,
see the table showing the copy pair statuses that are manipulated by the command, in the HP XP
P9000 for Business Continuity Manager Software Users Guide.
{QUICK|NORMAL}
Applies to Business Copy for Mainframe.
Specify the copy mode.
QUICK
Transit to the DUPLEX status quickly.
NORMAL
Transit to the DUPLEX status after copy completion.
{FORWARD|REVERSE}
Specify the copy direction.
Based on the information updated since transiting to the SUSPOP status, the differences are copied
for tracks and cylinders, and the DUPLEX status is recovered.
When the parameter is not specified in BC, the differences are copied from P-VOL to S-VOL.
When the parameter is not specified in CA, CAA, or CAJ, the differences of the copy pairs in the
SUSPOP status are copied.
A copy pair with the S-VOL SWAP status is not copied. Even for RESYNC, the direction of the copy
does not change.
FORWARD
In BC, the difference is copied from P-VOL to S-VOL.
In CA or CAA, or CAJ, the difference is copied from the primary site to the secondary site.
REVERSE
In BC, the difference is copied from S-VOL to P-VOL.
In CA or CAA, or CAJ, the difference is copied from the secondary site to the primary site.
DEVN(p-vol-device-number,s-vol-device-number) ~ <4-digit hexadecimal number, 4-digit
hexadecimal number>
Specify the device number of the copy pair (P-VOL and S-VOL) to operate. If you specify this
parameter after ATTIME suspend, execute the YKSUSPND command with the CANCEL parameter
specified.
238 CLI Commands