HP XP P9000 for Business Continuity Manager Software Reference Guide

Table 124 YKQUERY Command Return Code List (continued)
MeaningReturn Code
24
• An error occurred when the suspend processing was performed by using the
CAJ ATTIME suspend function.
• The status of the CAJ copy pair was invalid when the suspend processing was
performed by using the CAJ ATTIME suspend function.
• The suspend processing has started because the timeout period had elapsed
when the CAJ ATTIME suspend function was executed.
32
• I/O errors were encountered.
• A change in an I/O configuration definition was detected.
36
• An invalid or unknown element was found in the configuration.
• An inconsistency was detected between a copy group definition and an actual
copy group.
An error occurred while a REXX variable was being written.40
Terminating due to processing errors. This return code appears, for example, in
the following cases:
44
• A GETMAIN error has occurred.
• For CG containers specified by EXCTG ID, journal groups have not yet been
registered in EXCTG.
Terminating due to invalid parameters. This return code appears, for example,
when the copy pair corresponding to the device number specified with the DEVN
parameter is not found.
48
The command terminated abnormally. The user does not have permission to execute
this command.
128
YKRECVER Command
Applies to Continuous Access Synchronous for Mainframe, Continuous Access Synchronous for
Mainframe with the HyperSwap attribute, Continuous Access Asynchronous for Mainframe, and
Continuous Access Journal for Mainframe.
Format
YKRECVER
1
STEM(stem-name-1)
1
MSG(stem-name-2)
[
1
DEVN(p-vol-device-number,s-vol-device-number)]
Function
This command is a TSO/E command called from REXX scripts.
When copy pair operations from the primary site are disabled due to failure or other reasons, this
command dissolves a copy pair for the specified copy group from the secondary site.
When you use this command to dissolve a copy pair, the volume on the secondary site assumes
the SIMPLEX status, but the volume on the primary site takes the SUSPER status. Note, however,
that depending on the status of the primary site, the status of the volumes in the primary site do
not change even after the copy pair is dissolved.
The site names are for cases when the copy direction of copy pair configuration and the copy
direction which is actually recognized on the storage system are the same. For the opposite copy
direction, replace the primary site and secondary site with the secondary site and primary site
respectively. However, do not dissolve copy pairs during a planned outage.
Command details 235