HP XP P9000 for Business Continuity Manager Software Reference Guide

Table 116 YKINSCHK Command Output Items (continued)
ExplanationOutput item
Outputs the host ID that is currently enabled in the system.Current Host ID
• If no host ID was defined by using the YKSETENV command or for the IEASYMxx
parmlib member, 00 (default value) is output.
• If the host ID cannot be acquired, N/A is output.
• If the host ID is invalid because it is not a value from X'00' to X'1F', the value is
output, and FAULTY is output for Host ID Settings.
Outputs the host ID that was defined dynamically by using the YKSETENV command.Dynamically defined
Host ID
Outputs the host ID that was defined statically by using the IEASYMxx parmlib member.Statically defined
Host ID
If the host ID cannot be acquired, N/A is output. Even if the defined host ID is invalid
because it is not a value from X'00' to X'1F', the value is output.
Outputs the description of the Host ID.Directions
Output example
The following is an output example of the YKINSCHK command:
READY
YKINSCHK
Security Setting ..........: OK
User SVC Routine ..........: OK
Host ID Settings...........: OK
Facility Class Profiles Query : STGADMIN.YKA.BCM.YKQUERY
Facility Class Profiles Commands : STGADMIN.YKA.BCM.COMMANDS
Directions
The current setup is listed above.
An unregistered profile is listed as N/A.
The RACF settings are necessary in order to use CLI commands.
After a profile is defined in the RACF FACILITY class, a user can use
CLI commands by being given the access rights of the profile.
There are the following two kinds of profiles:
- Facility Class Profiles Query
- Facility Class Profiles Commands
To give a user the permissions necessary to use all of the BCM commands:
1. Make the RACF FACILITY class active.
2. Define the STGADMIN.YKA.BCM.COMMANDS profile in the FACILITY class.
3. Give the user the access rights of the profile.
To give a user the permissions necessary to use some of the BCM commands
(the reference commands):
4. Make the RACF FACILITY class active.
5. Define the STGADMIN.YKA.BCM.YKQUERY profile in the FACILITY class.
6. Give the user the access rights of the profile.
Version of User SVC for this program .............: v.r.m-nn(zz)
Current User SVC : SVC Number 200 Version v.r.m-nn(zz)
Dynamic registered User SVC : SVC Number 200 Version v.r.m-nn(zz)
Static installed User SVC : SVC Number 251 Version v.r.m-nn(zz)
Directions
The current users SVC routine registration number and version are listed
above.
User SVC numbers and versions that have not been acquired are listed as
N/A.
If a Dynamic registered User SVC exists, the Dynamic registered User SVC
will become the Current User SVC.
216 CLI Commands