HP XP P9000 for Business Continuity Manager Software Reference Guide

FORCE
If this parameter is specified, of those logical paths that are identified in the path set stored in the
path set structure specified by the STEM parameter, the command also deletes the paths that have
the shared attribute (those with the value Y assigned to
stem-name-specified-in-STEM-parameterPATH.n.Shared).
If this parameter is not specified, the command does not delete logical paths that have the shared
attribute.
TYPE({CU|DKC})
This parameter specifies the type (inter-CU logical path or inter-DKC logical path) of the logical
path to be deleted.
If neither this parameter nor any other parameters are specified, the command deletes all logical
paths.
CU
Out of the logical paths within the path set stored in the path set structure specified by the STEM
parameter, the logical paths that have CU set for
stem-name-specified-in-STEM-parameterPATH.n.type are deleted.
DKC
Out of the logical paths within the path set stored in the path set structure specified by the STEM
parameter, the logical paths that have DKC set for
stem-name-specified-in-STEM-parameterPATH.n.type are deleted.
NOTE:
• Before executing the command, create and load the path set definition file.
• If a message that contains sense information for the storage system is output, see the list of
error codes in the HP XP P9000 for Business Continuity Manager Software Messages and
then eliminate the cause of the error. Alternatively, in the Edit Logical Path Definition panel,
specify a different, valid volume on which a device scan has been performed, in CU, SSID,
and CCA in the path set definition file for the command execution target.
• If all of the volumes in the CU are Non Gen'ed volumes, load the route list before executing
the command.
Return Codes
Table 103 (page 196) lists the return codes to be returned when the YKDELPTH command terminates.
Table 103 YKDELPTH Command Return Code List
MeaningReturn Code
The command terminated abnormally, possibly because the user SVC routine has
not been included properly.
-4095 to -4040
The module cannot be loaded. Possible causes are as follows:-3
• The library dataset has not been linked.
• The module is protected by the RACF program control function.
An interruption occurred during execution.-1
The command completed normally.0
196 CLI Commands