HP XP P9000 for Business Continuity Manager Software Reference Guide

Table 85 Return codes displayed in the Copy Group Pair Status panel (continued)
MeaningReturn Code
file in use, as well as the actual storage system configuration information
and settings.
• If the device indicated by Primary Volume/Secondary Volume in the Copy
Group Pair Status panel is a remote site, then either the route list is not
specified, or the serial number of the storage system to which the device
belongs is not registered in the route list specified for the YKLOAD command.
Return code of the YKQRYDEV command.Other than the above
In the Path Set Status of Copy Group Pair panel, you can use the SORT command. For details
about how to use the SORT command, see “Command line commands” (page 11).
Pressing the F6=Sort key in the Path Set Status of Copy Group Pair panel displays the Sort Logical
Paths in the Path Set panel that sorts the logical paths in the path set. For details about the Sort
Logical Paths in the Path Set panel, see “Sort Logical Paths in Path Set Panel” (page 63).
Logical Path Status of Copy Group Pair Panel
When s is specified for the AC column in the Path Set Status of Copy Group Pair panel, the physical
paths within the logical paths used by the copy pair are displayed in the Logical Path Status of
Copy Group Pair panel.
Figure 89 (page 164) shows the Logical Path Status of Copy Group Pair panel.
Figure 89 Logical Path Status of Copy Group Pair Panel
Table 86 (page 164) describes the items in the Logical Path Status of Copy Group Pair panel.
Table 86 Contents of the Logical Path Status of Copy Group Pair Panel
DescriptionItem
Copy group IDCopy Group ID
Path typeType
• CU: Inter-control unit logical path
• DKC: Inter-disk controller logical path
Primary storage system serial numberS/NPrimary
Primary path group ID (path group ID in the forward direction)PathID
When the path type is CU, nothing is displayed.
Primary control unit numberCU
164 ISPF panels