HP XP P9000 for Business Continuity Manager Software Reference Guide

Table 84 Contents of the Path Set Status of Copy Group Pair Panel (continued)
DescriptionItem
Serial number of the primary storage systemSNPrimary
Primary path group ID (path group ID in the forward direction)ID
When the path type is CU, nothing is displayed.
Primary control unit numberCU
Primary SSIDSSID
Path directionDir
Serial number of the secondary disk controllerSNSecondary
Secondary path group ID (path group ID in the reverse direction)ID
When the path type is CU, nothing is displayed.
Secondary control unit numberCU
Secondary SSIDSSID
Status of the logical path used by the copy pairStatus
• ESTABLISHED n/n PORT(S): All defined physical paths have been
established (where n indicates the number of defined physical paths).
• ESTABLISHED m/n PORT(S): Among all of the physical paths defined
by the hardware, only those established are displayed (where m indicates
the number of physical paths in the ESTABLISHED status, and n indicates
the number of defined physical paths).
• INVALID: An error has occurred on a physical path.
The path information displayed in the Path Set Status of Copy Group Pair panel differs depending
on the copy type:
• When the copy type is CA/CAA, path information for the inter-control unit logical path in the
copy direction is displayed
• When the copy type is CAJ, path information for the bidirectional inter-disk controller logical
path or path information for all paths for which a path group ID is specified is displayed.
• When the copy type is BC, no path information is displayed.
The execution result of the YKQRYDEV command with the PATH parameter specified is displayed
in the RC column in the Copy Group Pair Status panel. “ Return codes displayed in the Copy Group
Pair Status panel” (page 163) describes the return codes displayed in the Copy Group Pair Status
panel.
Table 85 Return codes displayed in the Copy Group Pair Status panel
MeaningReturn Code
Successful completion.00
If no path information is displayed, then there is no path used by the copy pair
selected in the Copy Group Pair Status panel.
Path information cannot be displayed for one of the following reasons:04
• The device information during definition, as indicated by Primary
Volume/Secondary Volume in the Copy Group Pair Status panel, differs
from the device information reported by the storage system. View the Volume
Query Information panel for the relevant copy pair to check the configuration
Manage Copy Groups Panel (Copy Group Operation) 163