HP XP P9000 for Business Continuity Manager Software Reference Guide

• To select the device for which VSN111 is set to Volser, in the Pair Selection List (Primary) panel,
enter the following command:
SΔVOLSERΔVSN111ΔS
• To select the device for which F310 is set to Devn (the default field name, DEVN, can be
omitted), in the Pair Selection List (Primary) panel, enter the following command:
SΔDEVNΔF310ΔS
• To select the devices for which F310 through F320 are set to Devn (the default field name,
DEVN, can be omitted), in the Pair Selection List (Primary) panel, enter the following command:
SΔDEVNΔ'F310':'F320'ΔS
• To register a command device without specifying a value for Label (leaving Label blank) for
the storage system, enter the following command in the Route Status panel:
SΔLABELΔ'Δ'ΔB
NOTE: If you specify three parameters, the command interpreter assumes that the field name is
specified. If you specify two parameters, the command interpreter assumes that the field name is
omitted.
SORT command
Function
List items, displayed in a panel, are sorted by the SORT command based on the
specified field names. The sort order (ascending or descending) is defined for each
selected field.
Format
SORTΔ[field-name]
Parameter
field-name
For details about the specifiable field names and sort order, see the descriptions
for each panel. If you omit the field name, a pop-up panel will appear and you
can specify the sort key.
NOTE: If you specify a field name, you cannot sort on multiple items. If you specify an invalid
field name, a pop-up panel for specifying the sort key is displayed.
SCANPAIR command
Function
The SCANPAIR command displays the Scan Copy Pair Inside Storage System panel
that scans volumes of PPRC copy pairs.
Format
SCANPAIR
ERRCODE command
Function
The ERRCODE command displays the Error Code Help panel. If you enter an error
code on this panel, you can view the details for that error code. For details about
the Error Code Help panel, see “Error Code Help panel” (page 18).
Overview of ISPF panels 13