HP XP P9000 for Business Continuity Manager Software Messages

Table 10 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKL2x) (continued)
Explanation and recommended actionsMessage textMessage ID
No command devices were found.No command devices were
found.
YKL280E MSG
SC=36 RC=36 (file)
Correct the route definition in the route list definition file shown in
file.
file
Name of the XML file where the error was
detected
No command device was found that is defined in the route for
remote command issuance or with the specified route label.
No command devices are
defined for routes that issue
YKL281E MSG
SC=36 RC=36
(file:rec#)
Correct the route definition in the route list definition file identified
by file.
remote commands or for route
labels.
file
Name of the XML file where the error was
detected
rec#
Number of the line in the file identified by file
where the error was detected
The route label specified for the ROUTE parameter is not defined.The route label specified for
the ROUTE parameter has not
been defined.
YKL282E MSG
SC=36 RC=36 (file)
Correct the route definition in the route list definition file identified
by file.
file
Name of the XML file where the error was
detected
An attempt was made to load command device lines for which
no route label is specified because no route label is specified for
A route label is not specified
for the ROUTE parameter,
YKL283E MSG
SC=36 RC=36 (file)
the ROUTE parameter. However, route labels are defined for all
the command devices in the route list definition file shown in file.
even though a route label is
defined for all the command
devices.
Set an appropriate route label for the ROUTE parameter of the
YKLOAD command, or use the Edit Attribute panel to delete the
route labels of command devices in the route list definition file
shown in file.
file
Name of the XML file where the error was
detected
In a file for a copy group of the BC Z copy type, a copy pair has
been discovered for which the storage system serial numbers of
the P-VOL and S-VOL do not match.
PVOL & SVOL of BC pair is
in the different storage
system.
YKL284E MSG
SC=36 RC=36
(file:rec#)
Correct the line with the line number identified by rec# in the file
identified by file.
file
Name of the XML file where the error was
detected
rec#
Number of the line in the file identified by file
where the error was detected
68 Messages