HP XP P9000 for Business Continuity Manager Software Messages

Table 8 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKG2x) (continued)
Explanation and recommended actionsMessage textMessage ID
The storage system of the detected undefined
volume
CU#
The control unit number of the detected
undefined volume
CCA#
The command control address number of the
detected undefined volume
An S-VOL not defined in the disk configuration definition file was
detected among the PPRC copy pairs detected by the YKH2B
command.
Unable to resolve secondary
volume information.
SN=SerialNum, CU=CU#,
CCA=CCA#
YKH203W TSO
Check whether the detected S-VOL is defined in the disk
configuration definition file.
SerialNum
The storage system serial number of the detected
undefined volume
CU#
The control unit number of the detected
undefined volume
CCA#
The command control address number of the
detected undefined volume
A dynamic change was detected in an I/O configuration definition
when the YKH2B command was executed either without the HS
parameter or with HS(CHECK).
A dynamic configuration
change was detected.
DEVN=device-number
YKH204W TSO
Check the status of the device targeted by the YKH2B command,
correct any errors in the configuration or execution conditions (such
as the parameter setting or the times at which the command has
been executed), and then re-execute the command.
device-number
Device number being processed when a dynamic
change was detected in an I/O configuration
definition
Cnt Ac-S Z with the HyperSwap attribute cannot be used in this
storage system because 2DC configuration with HyperSwap and
This copygroup does not
support LinkageOption=HS.
SUPFNC=SUPFnc
YKH205W TSO
Cnt Ac-J Z is not supported. Use a device in which 2DC
configuration with HyperSwap and Cnt Ac-J Z can be used. Also,
if scanning was not performed after the storage system microcode
was updated, perform a scan.
SUPFnc (hexadecimal number)
Value for the version (minimum value) of the
storage system support function used in the copy
group
Nothing or an invalid value is assigned to the parameter identified
by name.
Unable to execute without
valid name parameter.
YKJ000E TSO
RC=48
name
Parameter name
The parameter identified by name is too long.name parameter is too long.YKJ001E TSO
RC=48
List of messages 49