HP XP P9000 for Business Continuity Manager Software Messages

Table 8 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKG2x) (continued)
Explanation and recommended actionsMessage textMessage ID
The specified prefix is being used by another program.The specified PREFIX is
being used by another
program.
YKH101E TSO
Check the value specified for the prefix.
An error occurred during execution of the YKH2B command.Error occurred during
execution. Cmd=info
YKH102E TSO
See the explanation corresponding to the message ID of the error
message indicated by message-text and take appropriate action.
msg=message-text:
message-value:
message-severity
Also see the additional information indicated by message-value
and message-severity and take appropriate action. If the problem
is not resolved, contact service representative.
info
Maintenance information
message-text
Error message
message-value
Additional information about the error message
If no additional information is available, a space
is displayed.
message-severity
Additional information about the error message
If no additional information is available, a space
is displayed.
The error messages message-text, message-value, and
message-severity are displayed in the TSO/E terminal. Depending
on the length of the error messages, they might extend over several
lines.
No copy pair information was acquired from the volume with the
device number indicated by Devn. There might not be a volume
for the specified device number.
No information was
acquired for DEVN=Devn
YKH200W TSO
If a volume does exist for the specified device number, check the
channel settings.
Devn
Device number assigned to the volume from
which no copy pair information was acquired
No copy pair information was acquired from the volume to which
the device number Devn was assigned because no I/O paths are
available.
No I/O paths are available
for the specified devices.
DEVN=Devn
YKH201W TSO
Verify the I/O path settings
Devn
The device number of the volume whose
information acquisition was skipped
A P-VOL not defined in the disk configuration definition file was
detected among the PPRC copy pairs detected by the YKH2B
command.
Unable to resolve primary
volume information.
DEVN=Devn,
SN=SerialNum, CU=CU#,
CCA=CCA#
YKH202W TSO
Check whether the detected P-VOL is defined in the disk
configuration definition file.
Devn
The device number of the detected undefined
volume
SerialNum
48 Messages