HP XP P9000 for Business Continuity Manager Software Messages

Table 8 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKG2x) (continued)
Explanation and recommended actionsMessage textMessage ID
The YKH2B command terminated.YKH2B completed.
RC=return-code
YKH001I TSO
return-code
The return code of the YKH2B command
0: The command ended successfully. One or
more copy group definition files were created.
4: Indicates that one of the following occurred:
• The command ended successfully. No copy
pair was detected within the range of the
specified device numbers.
• A copy group definition file was created, but
volume information not defined in the disk
configuration definition file for the site
specified in the DAD parameter was detected
among copy pairs within the range specified
in the DEVN parameter.
• A copy group definition file was created, but
a change was detected in the I/O
configuration when the YKH2B command was
executed without specifying the HS parameter
or the YKH2B command was executed by
specifying HS(CHECK).
• A copy group definition file was created, but
a storage system that does not support 2DC
configuration with HyperSwap and Cnt Ac-J
Z was detected.
8: An I/O error occurred in a volume within the
scan range. Copy group definition files were
created for the volumes that were successfully
detected.
44: The processing was cancelled due to an
error. The copy group definition file was not
created.
48: The command ended due to an invalid
parameter.
No copy pairs were detected within the specified range.No copy pair was
discovered.
YKH002I TSO
Check the operating range and status of the copy pair that you
want to acquire, and execute the YKH2B command again. If the
copy pair status is SIMPLEX, the YKH2B command will not detect
the copy pair. Note that if you specified HYPERDELTA(CHECK)
and HyperSwap is disabled, the YKH2B command will not detect
any copy pairs. In addition, if you execute the YKH2B command
without specifying the HS parameter or execute the YKH2B by
specifying HS(CHECK) while HyperSwaps are disabled, copy pairs
cannot be detected.
Check the following, and then re-execute the command:Missing or invalid
parameter: parameter-name
YKH100E TSO
• Make sure that the required parameter indicated by
parameter-name was specified.
• Make sure that the value specified for the required parameter
indicated by parameter-name is valid.
parameter-name
Name of the invalid or missing parameter
List of messages 47