HP XP P9000 for Business Continuity Manager Software Messages

Table 2 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKA0x) (continued)
Explanation and recommended actionsMessage textMessage ID
Check the following, and then re-execute the command:parameter-name
• Make sure that the required parameter indicated by
parameter-name was specified.
• Make sure that the value specified for the required parameter
indicated by parameter-name is valid.
• Make sure that different device address domain (DAD) IDs for
the primary and secondary sites are specified for the DAD
parameter.
parameter-name
Name of the invalid or missing parameter
The specified prefix is being used by another program.The specified PREFIX is
being used by another
program.
YKB101E TSO
Check the value specified for the prefix.
An error occurred during execution of the YKP2B command.Error occurred during
execution.
Cmd=command-name
YKB102E TSO
See the explanation corresponding to the message ID of the error
message indicated by message-text and take appropriate action.
msg=message-text:
message-value:
message-severity
Also see the additional information indicated by message-value
and message-severity again, take appropriate action. If the problem
is not resolved, contact an HP service representative.
command-name
CLI command name
message-text
Error message
message-value
Additional information about the error message
If no additional information is available, a space
is displayed.
message-severity
Additional information about the error message
If no additional information is available, a space
is displayed.
The error messages message-text, message-value, and
message-severity are displayed in the TSO/E terminal. Depending
on the length of the error messages, they might extend over several
lines.
No copy pair information was acquired from the volume to which
the device number was assigned.
No information was
acquired for
DEVN=device-number
YKB200W TSO
There might not be a volume for the specified device number. If the
volume exists for the specified device number, check the channel
settings.
device-number
Device number assigned to the volume from
which no copy pair information was acquired
No copy pair information was acquired from the volume to which
the device number Devn was assigned because no I/O paths are
available. Verify the I/O path settings.
No I/O paths are available
for the specified devices.
DEVN=Devn
YKB201W TSO
Devn
List of messages 31