HP XP P9000 for Business Continuity Manager Software Messages

Table 1 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YK80x) (continued)
Explanation and recommended actionsMessage textMessage ID
A permanent license for Business Continuity Manager Basic is
required.
If function is Cnt Ac-S Z Sync Extended CTG:
A permanent license for Business Continuity Manager Extended CT
Group is required.
If function is Cnt Ac–J 4x4 Extended CTG:
A permanent license for Business Continuity Manager Cnt Ac-J Z
4x4 Extended CTG is required.
Table 2 Business Continuity Manager error messages and corresponding troubleshooting actions
(message ID YKA0x)
Explanation and recommended actionsMessage textMessage ID
An error was detected during parameter analysis.Supplied parameters invalidYKA000T TSO
The handle value assigned to the HANDLE parameter is invalid.HANDLE() value not validYKA001E TSO
The OP(GET) and OP(CLOSE) requests require the HANDLE
parameter to be specified.
HANDLE() parameter
required for this operation
YKA002E TSO
Use the handle value returned by the OP(OPEN) request in the
YKA098I message.
The OP parameter is missing.OP(OPEN|GET|CLOSE)
option required
YKA003E TSO
Specify the OP parameter.
An attempt to acquire the IEA494I console message, IOSHM0414I
console message, or the message specified in the MSGID parameter
Buffer full; messages
discarded
YKA004E TSO
of the YKCONMSG command failed. This problem might occur when
console message traffic is too high or when the YKCONMSG
command issuance interval is too long.
When you receive this message, issue the YKQUERY command to
check the copy pair status.
A system error was detected.SYSTEM ERROR. error-typeYKA006E TSO
Contact technical support for assistance.
error-type
Type of system error
The value specified in the TIMEOUT parameter is invalid.TIMEOUT() value not validYKA007E TSO
If GET or CLOSE is specified in the OP parameter, you cannot
specify the TIMEOUT parameter.
TIMEOUT() parameter
cannot be specified for this
operation
YKA008E TSO
Specify OPEN in the OP parameter, and then specify the TIMEOUT
parameter.
The value specified in the MSGID parameter is invalid.MSGID() value not validYKA009E TSO
If GET or CLOSE is specified in the OP parameter, you cannot
specify the MSGID parameter.
MSGID() parameter cannot
be specified for this
operation
YKA010E TSO
Specify OPEN in the OP parameter, and then specify the MSGID
parameter.
Processing of the YKCONMSG command with OP(GET) specified
exceeded the time specified in the TIMEOUT parameter, but the
No message foundYKA096I TSO
IEA494I console message, IOSHM0414I console message, or
List of messages 29