HP XP P9000 for Business Continuity Manager Software Messages

Table 62 Details of error codes C3xx (continued)
Type of errorError detailsError
code
OthersTHPzPATHCMDCAJCAACABC
(YKBLDCMD) cannot be executed
because the specified volume
does not exist.
Table 63 Details of error codes CBxx
Type of errorError detailsError
code
OthersTHPzPATHCMDCAJCAACABC
Not outputOutputNot outputA copy pair cannot be made
because there was an attempt
CB10
to make a copy pair for both
directions with the same C/T
group ID.
Not outputOutputNot outputA CAA copy pair cannot be
created for one of the following
reasons:
CB12
• The C/T group ID specified
in the RCU is already used
for CAJ(OPEN).
• A total of 128 C/T groups
are used in the RCU for
CAJ(OPEN) and
CAA(MF/OPEN).
Not outputOutputNot outputA copy pair cannot be added
to a C/T group where the
CB18
P-VOL and the S-VOL are being
swapped.
Not outputOutputNot
output
A dummy volume cannot be
created on the S-VOL.
CB1D
Not outputOutputNot
output
The current RCU version does
not support Fibre CA or CAA.
CB1F
Not outputOutputNot
output
Fibre CA or CAA has not been
installed on the RCU.
CB60
Not outputOutputNot outputCopy pairs with Fibre and
ESCON paths cannot exist
within the same C/T group.
CB61
Not outputOutputNot
output
Copy pairs with Fibre and
ESCON paths cannot exist
within the same storage system.
CB62
Not outputOutputNot
output
The storage system type of the
MCU is not supported (not
3990-6/6E, or is 2105).
CB64
Not outputOutputNot outputThe upper limit of 4,096 (or
more) copy pairs cannot be
CB69
made within the same C/T
group by RCU.
Not outputOutputNot
output
A copy pair cannot be made
because the specified S-VOL is
defined as a command device.
CB78
Details of error codes 233